Posted in Uncategorized

Top 10 Rdq Micro M8n Glonass GPS Module – GPS System Accessories

As an Amazon Associate I earn from qualifying purchases.

1. Geekstory

#ad

BN-220 Dual GPS Glonass Module Navigation TTL Level 9600bps + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Flight Control Geekstory

#ad
Geekstory #ad - But it has no compass. When you use it for raspberry Pi, there is no driver needed but you need to install software. The tx led flash means gps module output normally.

The pps led flash means gps module locate your place. Bn-220 has flash to save configuration, so you do not need to reset data next time when you use it. To make it be rs232 output, you need to use one TTL to RS232 converter cable. The product documentation link cannot be displayed. If you need technical documentation, in the new page, please click “Geekstory”you can find "Sold by Geekstory" under Buy Now button, click “Ask a question” to email us. If you need gps with flash and compass, please buy bn-880 from Geekstory. Data level : ttl or rs-232, default ttl level.
BrandGeekstory #ad
ManufacturerGeekstory #ad

2. Geekstory

#ad

BN-180 GPS Module UART TTL Dual Glonass GPS Car Navigation with GPS Antenna for Arduino Raspberry Pi Pixhawk Aircraft CC3D F3 Flight Controller Geekstory

#ad
Geekstory #ad - The tx led flash means gps module output normally. The pps led flash means gps module locate your place. This bn-180 gps module can show your speed.

Data level : ttl or rs-232, default ttl level. What you will get: 1 x BN-180 GPS Module. This bn-180 gps module does not have flash and cannot be saved. Here is connection with RPi, black to gnd, red to 3. 3v, green to txd, white to rxd. When you use it for Raspberry Pi, there is no driver needed. 72 searching channel support rate : 4800bps to 921600bps, Default 9600bps. To make it be rs232 output, you need to use one TTL to RS232 converter cable.
BrandGeekstory #ad
ManufacturerGeekstory #ad
Part Number5823923123
ModelFZ2917

3. D-FLIFE

#ad

BN-220 Dual GPS Glonass Module Navigation TTL Level 9600bps + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Flight Control

#ad
D-FLIFE #ad - Bn-220 gps receiver module ttl dual gps glonass navigation w/flash + gps passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Aircraft Flight Control RC FPV Drone.

The data output when the tx led flashing in blue; PPS LED not bright when GPS not fixed, flashing in red when fixed. Bn-220 has flash to save configuration, so you do not need to reset data next time when you use it. Data level: ttl or rs-232, default ttl level. To make it be rs232 output, you need to use one TTL to RS232 converter cable. Great accuracy: 2. 0 m cep 2d rms sbas enable typical open sky at position Horizontal, 01m/sec 95% sa off at velocity, 1us synchronized to GPS time at Timing.
BrandD-FLIFE #ad
ManufacturerD-FLIFE #ad

4. DIYmalls

#ad

DIYmalls BN-880 GPS Module w/Flash HMC5883 Compass + GPS Active Antenna Support GPS Glonass Beidou for Arduino Raspberry Pi Pixhawk Betaflight CC3D F4 Flight Control

#ad
DIYmalls #ad - Bn880 gps module is suitable for open source flight controller, not for flight control with SCM. If you have any problem, in the new page, please contact seller as follow: click "DIYmalls"you can find "Sold by DIYmalls" under Buy Now button, click "Ask a question".

Bn 880 gps module has flash to save configuration. So you do not need to reset data when you use it next time. You can buy more bn180 bn220 gps here, https://www. Amazon. Com/nextion. Bn 880 gps module is dual module compass, with and electronic compass IC HMC5883L. When you use it for raspberry Pi, there is no driver needed but you need to install software.
BrandDIYmalls #ad
ManufacturerDIYmalls #ad

5. Vohappy

#ad

BN-220 GNSS GLONASS Dual GPS Module Antenna Built-in LED Flash TTL Level 9600bps 4M

#ad
Vohappy #ad - To make it be rs232 output, you need to use one TTL to RS232 converter cable. Great accuracy: 2. 0 m cep 2d rms sbas enable typical open sky at position Horizontal, 01m/sec 95% sa off at velocity, 1us synchronized to GPS time at Timing. Data level: ttl or rs-232, default ttl level. The data output when the tx led flashing in blue; PPS LED not bright when GPS not fixed, flashing in red when fixed. Bn-220 has flash to save configuration, so you do not need to reset data next time when you use it. When you use it for raspberry Pi, there is no driver needed but you need to install software.
BrandVohappy #ad
ManufacturerVohappy-12 #ad

6. SoloGood

#ad

GLONASS Galileo for UAV System Robots RC FPV …, Matek GPS Module,SAM-M8Q Mini FPV GPS Module

#ad
SoloGood #ad - 72-channel m8 engine gps l1c/a, sbas l1c/a, glonass l1of, qzss l1 saif, qzss l1C/A, Galileo E1B/C. Build-in embedded GNSS patch antenna, low power consumption. Features an additional front-end LNA for optimized performance and a front-end SAW filter for increased jamming immunity. The 15x15 mm patch antenna provides the best compromise between the performance of a Right Hand Circular Polarized RHCP antenna and a small size to be integrated in any design. On-board ultra low noise 3. 3v voltage regulator and RF filter for noise blocking.
BrandSoloGood #ad
ManufacturerMatek #ad
Part Number0993

7. Garmin

#ad

Garmin eTrex 10 Worldwide Handheld GPS Navigator

#ad
Garmin #ad - Waas enabled gps receiver with hotFix and GLONASS support for fast positioning and a reliable signal. Rugged handheld navigator with preloaded worldwide basemap and 2. 2 inch monochrome display. Support for paperless geocaching and Garmin spine mounting accessories. Waterproof to ipx7 standards for protection against splashes, rain, etc. See high and low elevation points or store waypoints along a track start, finish and high/low altitude to estimate time and distance between points. Power with two aa batteries for up to 20 hours of use best with Polaroid AA batteries.
BrandGarmin #ad
ManufacturerGarmin #ad
Height2.1 Inches
Length1.3 Inches
Weight310 Grams
Width4 Inches
Part Number0100097000 etrex 10
Model010-00970-00
Warranty1 year limited

8. D-FLIFE

#ad

D-FLIFE BN-880 GPS Module U8 with Flash HMC5883 Compass + GPS Active Antenna Support GPS Glonass Beidou Car Navigation for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

#ad
D-FLIFE #ad - It is dual module compass, with and electronic compass IC HMC5883L. Beitian bn-880 is suitable for Open source flight controller, not for flight control with SCM. When you use it for raspberry Pi, there is no driver needed but you should install software. Dits data level is ttl or rs-232, default ttl level. So you do not need to reset next time when you use it. To make it be rs232 output, you need to use one TTL to RS232 converter cable. This gps module has flash to save configuration.
BrandD-FLIFE #ad
ManufacturerD-FLIFE #ad

9. NEXTION

#ad

BN-220 GPS Module TTL Dual GPS Glonass Navigation with Flash + GPS Passive Antenna for Arduino Raspberry Pi Pixhawk F3 CC3D Betaflight F4 Aircraft Flight Control RC FPV Drone

#ad
NEXTION #ad - To make it be rs232 output, you need to use one TTL to RS232 converter cable. When you use it for raspberry Pi, there is no driver installation needed but you need to install software.

Tx led flash means gps module output normally, and PPS LED flash means gps module locate your place. Bn220 gps module has flash to save configuration, so you do not need to reset data when you use it next time. If you need gps with flash and compass, please buy bn-880 gps. If you have any problem, please contact seller as follow: click "DIYmalls"you can find "Sold by DIYmalls" under Buy Now button, in the new page, click "Ask a question". Data level : ttl or rs-232, default ttl level. But it has no compass.
BrandNEXTION #ad
ManufacturerDIYmalls #ad
Modelbn-220

10. MakerFocus

#ad

GPS Module GPS NEO-6MAr duino GPS, Drone Microcontroller GPS Receiver Compatible with 51 Microcontroller STM32 Ar duino UNO R3 with IPEX Antenna High Sensitivity for Navigation Satellite Positioning

#ad
MakerFocus #ad - When using it, please make sure that the GPS module is in an open location. With a usb interface, the default distribution of active antenna, you can directly use the phone data cable on the computer point of view positioning effect; With IPEX antenna interface, can be quickly positioned.

Note: this gps module will not search for signals when the weather is bad, and it will not search for stars indoors. Usb directly connected to the computer, no need for external serial module, That is, with the host computer-owned serial port function, send IPX interface active antenna!. Gpsbaud needs to be set to 9600 instead of 4800; pps pin is not needed unless using the gps to drive a hardware high precision clock; GT-U7 main module GPS module using the original UBLOX 7th generation chip, miniaturization, Software is compatible with NEO-6M.

Gt-u7 module, low power consumption, with high sensitivity, its extremely high tracking sensitivity greatly expanded its positioning of the coverage.
BrandMakerFocus #ad
ManufacturerMakerFocus #ad
Height0.39 Inches
Length1.09 Inches
Width3.94 Inches
Part NumberSN12SF83QOH11452IC